·
Vertical Type: TESASCOPE 300V, TESASCOPE 500V
· Horizontal Type: TESASCOPE 355H
TESASCOPE 300V |
|
TESA SCOPE 300V are
ideally suited for the non-contact measurement of components
that needs a magnification upto 100X- Whatever the material
is and their shape.
The high quality of the projected
image provides the operator with the reliability and dependability
for accurate measurements
Features
· 300mm diameter rotary screen
with the chart clips, cross line 30, 60 and 90 degrees.
· Solid steel construction.
· Profile Illumination with the Green filter.
· Fibre Optic Surface Illumination.
· “SAVE LAMP” configuration- That is, the light goes
automatically Off when there is no stage movement for several
minutes. This increases the bulb life by 5 times.
· Quick change of the bayonet lens mount.
· RS232C Data output.
· Drawings mount in the side.
· Hard anodised stabilised stage with the clamping
slot for tooling, equipped with the linear glass scales with
0.001mm Resolution.
· 100mm Focus travel.
· Maximum weight on table is 20kgs.
· Built in Angular readout (degrees/minutes).
· Calibration certificate according to VDI-VDE 2617
– B89 4.1.1997.
TESASCOPE 355H
TESA SCOPE 355H are ideally
suited for the non-contact measurement of components that
needs a magnification upto 100X.
The high quality of the projected
image provides the operator with the reliability and dependability
for accurate measurements.
Features
· 355mm
diameter rotary screen with the chart clips, cross line 30,
60 and 90 degrees.
· Solid steel construction.
· Profile Illumination with the Green filter.
· Fibre Optic Surface Illumination.
· “SAVE LAMP” configuration- That is, the light goes
automatically Off when there is no stage movement for several
minutes. This increases the bulb life by 5 times.
· Quick change of the bayonet lens mount.
· RS232C Data output.
· Drawings mount in the side.
· Hard anodised stabilised stage with the clamping
slot for tooling, equipped with the linear glass scales with
0.001mm Resolution.
· 80mm Focus travel.
· Maximum weight on table is 20kgs.
· Built in Angular readout (degrees/minutes).
· Calibration certificate according to VDI-VDE 2617
– B89 4.1.1997.
Read-out/DISPLAY
There are three types of Read-out
available.
TS-100
TS-200
TS 200 E
Capabilities of TS100
This is
a simple read-out, which has the following
X/Y Read-out
1mm resolution
Inch/mm switchover
Independent zero set for X/Y
Absolute and incremental measurement
X/Y Linear compensation
Profile and Surface Illumination control
RS232C data output
3 to 10 entered points for Diameter
3 to 10 entered points for Radius
Distances from the last datum radius or diameter
Auto Enter function
|
 |
| Capabilities of
TS200 This
is a read-out with more features
LCD Screen
1mm resolution
Inch/mm switchover
Cartesian and polar co-ordinates
Programming features
X/Y Linear compensation
Part view printing
RS232C data output
Scale error detection
Plus It can give the
Skew, Point, Radius, Diameter, Arc, line, Distance,
Slot, Perpendicularity, Parallelism, Given point, Given
diameter and Auto Enter function
Capabilities
of TS200-E
Same as the TS 200 features
but this can capture the data when the table passes
from dark to bright and bright to dark. Thanks to the
fibre Optic element edge detector. This will reduce
drastically or make nil Appraiser variation.
|
 |
